Follow the signal by code

The washer cannot drain the water within the expected time.

The washer could not balance the load for spinning.

The washer detected a water-supply problem.

Moisture or an abnormal water-level condition was detected.

The leakage-protection system detected water in the dishwasher base.

The dishwasher is not draining properly.

The washer is taking too long to drain or is not draining.

The washer is unable to drain correctly within the expected time.

The washer detected a water-flow problem involving filling or drainage.

The dishwasher has a drainage problem.

The pump-out portion of the drain cycle has exceeded two minutes.

The total pump-out cycle has exceeded seven minutes.

The dishwasher failed to drain.

The detergent cup is blocked from opening fully.

A heat-pump motor circuit fault was detected at the main control board.

A main-control-board relay fault was detected.

An internal heat-pump heater fault was detected.

The dishwasher filter is blocked.

The drain pump is blocked, or its cover is loose or missing.

The electrical supply voltage is too low.

A problem was detected with water entering the dishwasher or the filling system.

A problem was detected with water entering the dishwasher or the filling system.

The washer detected a drainage problem.

The washer detected excessive suds.

The dryer detected an exhaust restriction of about 80 percent.

The dryer detected an exhaust restriction of about 90 percent.

The dryer detected an exhaust restriction of about 95 percent.